Master/ Slave Licensing

Registry Settings

All registry values relating to master/ slave communication are set under key:

HKEY_LOCAL_MACHINE\Software\Sytel\Dialer

The values are as follows:

1. The port for master/ slave communication is set using:

   Value Name	Type	Default Value
   LicensingServerPort	REG_DWORD	5321

   The default can be changed by setting the value to the port number to be used. This value needs to be set on both master and slave, and must be the same value on each.

2. The slave may configure up to 2 master servers. This is to assist with disaster recovery. In the case of outage on a licensing master server, the slave will attempt to connect to a second master.

   The master server configuration on the slave is stored in the following registry values:

   Value Name	Type	Default Value
   LicensingServer1Name	REG_SZ	sytellicense1.no-ip.com
   LicensingServer2Name	REG_SZ	sytellicense2.no-ip.com

   These defaults are in place because in future Sytel plans to provide licensing services to some customers.

3. From V10.6.925 - An otherwise unlicensed installation of CallGem can attempt to connect to a master server. To allow this, set this value to 1.

   Value Name	Type	Default Value
   UnlicensedSlave	REG_DWORD	0